This is the Isolé power strip w/ personal sensor. The Isolé IDP-3050 is an energy-saving control system that provides maximum surge and noise suppression while keeping plug load equipment off when there is no occupancy. It consists of an eight-outlet power strip and a personal occupancy sensor.

The IDP-3050 turns plug load devices on and off based on occupancy. The personal sensor connects to the eight-outlet power strip with the attached cable. The power strip contains six outlets controlled by occupancy and two outlets that are uncontrolled. The IDP-3050 automatically turns all controlled devices on when the workspace is occupied, and off when the workspace has been unoccupied for the user-defined time delay. Uncontrolled devices remain on regardless of occupancy. Check out Wattstopper DLM products here.

• Eight outlets; six controlled, two uncontrolled
• Surge and noise suppression protects desktop equipment
• Ground protected for safety; will not operate without a grounded outlet
• Two LEDs to indicate: 1) correct wiring and grounding; 2) surge protection is functioning
• Installation requires no hardwiring
• Flat offset plug for wire management
• One uncontrolled outlet and one controlled outlet are wall transformer-enabled
• Plugs into a standard three-prong outlet
• Uses latest passive infrared (PIR) technology to detect occupancy
• User-adjustable time delay of 30 seconds to 30 minutes
• Multi-level Fresnel lens for superior occupancy detection
• 120° coverage, up to 300 square feet
• ASIC technology reduces components and enhances reliability
• Instantaneous response time

WattStopper WRC-15/20 AMP WIRELESS RECEPTACLE CONTROL. Wireless Receptacle Control products facilitate Auto-On/AutoOff occupancy-based control of plug loads without the need to wire receptacles to power packs. A WRC transmitter works with WRC RF-enabled relay-controlled receptacles.

The 24VDC WRC-TX is wired to an occupancy sensor and a power pack to transmit On/Off signals to bound receptacles. A relay in each WRC receptacle switches the controlled outlet(s)
in response to the transmission. One transmitter can be bound
to up to 16 WRC receptacles, each with one or two controlled
outlets. In addition, each WRC receptacle has feed thru capability for downstream control of additional outlets.

Features

RF Transmitter (WRC-TX)
• Works with all 24VDC Wattstopper occupancy sensors and power packs
• Two mounting options for convenient installation in acoustic tile or to other surfaces
• Operates in quiet 915 MHz band to avoid interference
• LED indicator communicates status during binding
• The product meets the materials restrictions of RoHS RF

Receptacles (WRC Series)
• Choice of 15A or 20A rating
• Duplex receptacles with a choice of one or two controlled outlets
• Labeling meets NEMA requirements for controlled receptacles
• LED indicator communicates status during binding
• The product meets the materials restrictions of RoHS

Specifications

RF Transmitter
• Operating voltage: 24VDC
• Current consumption: 3mA
• Mounts to acoustic tile or other surface via keyhole mounting
• FCC Part 15 compliant Controlled Receptacles
• Operating voltage: 125VAC
• Load rating: 15A (WRC-15) or 20A (WRC-20)
• Auto ground strap construction
• Terminals for power feed-thru

RF System (Transmitter and Receptacles)
• NEMA-approved labeling for controlled receptacles
• Frequency: 915 MHz band
• Communication range: 30’ in obstructed application; up to 150’ with clear line of sight
• One transmitter can bind to up to 16 controlled duplex receptacles
• Operating conditions; for indoor use only
• UL and cUL listed
• Five year warranty

For other items like the WattStopper WRC-15/20 AMP WIRELESS RECEPTACLE CONTROL click here.

For more information on WattStopper’s line of lighting control solutions click here.

This is the plug load RF transmitter. Wireless Receptacle Control products facilitate Auto-On/AutoOff occupancy-based control of plug loads without the need to wire receptacles to power packs. A WRC transmitter works with WRC RF-enabled relay-controlled receptacles.

The 24VDC WRC-TX is wired to an occupancy sensor and a power pack to transmit On/Off signals to bound receptacles. A relay in each WRC receptacle switches the controlled outlet(s) in response to the transmission. One transmitter can be bound to up to 16 WRC receptacles, each with one or two controlled outlets. In addition, each WRC receptacle has feed thru capability for downstream control of additional outlets. Check out Wattstopper DLM products here.

RF Transmitter (WRC-TX)

• Works with all 24VDC Wattstopper occupancy sensors and power packs
• Two mounting options for convenient installation in acoustic tile or to other surfaces
• Operates in quiet 915 MHz band to avoid interference
• LED indicator communicates status during binding
• The product meets the materials restrictions of RoHS

WattStopper WRC-TX-LM RF TRANSMITTER DLM (DIGITAL LIGHT MANAGEMENT). Wireless Receptacle Controls facilitate occupancy-based AutoOn/Auto-Off control of plug loads without the need to wire
receptacles to room controllers. A WRC transmitter works with
WRC RF-enabled relay-controlled receptacles.

The WRC-TX-LM operates on Class 2 power supplied to a DLM local network by one or more room controllers, and connects via an RJ45 connector on a 6” pigtail. It transmits On/ Off signals from all DLM occupancy sensors connected to the local network to all bound receptacles. A relay in each WRC receptacle switches the controlled outlet(s) in response to the transmission. One transmitter can be bound to up to 16 WRC receptacles, each with one or two controlled outlets. In addition, each WRC receptacle has feed thru capability for downstream
control of additional outlets.

Features

• Works with all DLM occupancy sensors
• Digital Lighting Management components plug together on a free-topology Category 5e DLM local network
• Two mounting options for convenient installation in acoustic tile or to other surfaces
• Operates in quiet 915 MHz band to avoid interference
• LED indicator communicates status during binding
• The product meets the materials restrictions of RoHS RF Receptacles (WRC Series)
• Choice of 15A or 20A rating
• Duplex receptacles with a choice of one or two controlled outlets
• Labeling meets NEMA requirements for controlled receptacles
• LED indicator communicates status during binding
• The product meets the materials restrictions of RoHS

Specifications

RF Transmitter
• Input voltage: 24VDC from DLM local network
• Current consumption: 3mA
• DLM local network connection: 1 RJ45 port via RJ45 plug and coupler (included)
• Mounts to acoustic tile or hard surface
• FCC Part 15 compliant Controlled Receptacles
• Operating voltage: 125VAC
• Load rating: 15A (WRC-15) or 20A (WRC-20)
• Auto ground strap construction
• Terminals for power feed-thru RF System (Transmitter and Receptacles)
• NEMA-approved labeling for controlled receptacles
• Frequency: 915 MHz band
• Communication range: 30’ in obstructed application; up to 150’ with clear line of sight
• One transmitter can bind to up to 16 controlled duplex receptacles
• Operating conditions; for indoor use only
• UL and cUL listed
• Five year warranty

For other items like the WattStopper WRC-TX-LM RF TRANSMITTER DLM (DIGITAL LIGHT MANAGEMENT) click here.

For more information on WattStopper’s line of lighting control solutions click here.

This is the wireless receptacle controls from Wattstopper. Wireless Receptacle Control products facilitate Auto-On/Auto-Off occupancy-based control of plug loads without the need to wire receptacles to power packs. A WRC transmitter works with WRC RF-enabled relay-controlled receptacles.

The 24VDC WRC-TX is wired to an occupancy sensor and a power pack to transmit On/Off signals to bound receptacles. A relay in each WRC receptacle switches the controlled outlet(s) in response to the transmission. One transmitter can be bound to up to 16 WRC receptacles, each with one or two controlled outlets. In addition, each WRC receptacle has feed thru capability for downstream control of additional outlets. Check out Wattstopper DLM products here.

RF Receptacles (WRC Series)

• Choice of 15A or 20A rating
• Duplex receptacles with a choice of one or two controlled outlets
• Labeling meets NEMA requirements for controlled receptacles
• LED indicator communicates status during binding
• The product meets the materials restrictions of RoHS